KEMO Spannungswandler 24/12VDC, 3A

von 24 V/DC auf 12 V/DC (13,8 V/DC), max. 3 A
For operation of 12 V/DC devices at a 24 V/DC lorry or boat battery. Short circuit-proof, shock-proof module.

IMPORTANT INSTALLATION INSTRUCTIONS, PLEASE NOTE!
Depending
on the load the module heats up. The heat is dissipated from the
aluminum plate at the bottom of the module. Under certain circumstances
it must be mounted on a cooling surface according to installation
instructions. It is important that the module is fixed with 4 M3 screws
(or 2.9mm metal screws) on the cooling surface. This may be the back
wall of a metal casing. The aluminum plate on the bottom of the module
must not bend, do not use larger screws and do not drill larger holes.
The screw heads must rest on the plate of the module, rather than on the
plastic edge of the module! During assembly, the module should not be
curled up (if the ground is not flat). The reason:on the inside of the
aluminum base of the module the thin insulating layer are directly
soldered on the electronic SMD components. When the aluminum floor of
the module curls up, the joints and the module start loosen and the
module is defective. Please ensure that the maximum specified
temperature (as specified in the modules description) is not exceeded.
Otherwise apply a larger cooling plate.

TECHNICAL DATA
Input
voltage24 - 26 V/DCOutput voltageapprox. 13.8 V/DC (equivalent to a full
loaded 12 V/DC battery)Maximum current3ADimensionsapprox. 87 x 60 x
33mm (with mounting bottom)