Ampire BTR100 - Bluetooth Receiver

If you want to be able to listen to your music, audio books or navigation wirelessly via Bluetooth in the car, then the Bluetooth receivers of the BTR series are the solution. You can retrofit wireless A2DP Bluetooth audio streaming to most navigation and car radio systems with the Ampire Bluetooth receiver.

The connection is easy to set up and is automatically restored via Bluetooth 4.0. The BTR series uses the Bluetooth protocol for headphones on your smartphone and does not affect the functionality of your Bluetooth hands-free system.

The BTR100 Bluetooth Receiver has been developed for navigation and car radio systems with a cinch input (RCA) and an on-board network of 12 volts.

FURNISHING:

• splash-proof design, marine certified
• automatic activation
• automatic remote output
• QDL licensed Bluetooth 4.0 CRS I9chip (CSR8635)
• A2DP in the highest EDR specification
• BT audio streaming also of lossless files such as wave, flac, lossless, etc.
• Cinch (RCA) connections with signal output 1.0V
• SSID display name: BTR100
• 10m range

SMARTPHONE COMPATIBILITY

• Android
• Apple iOS
• Microsoft

CONNECTIONS:

• Blue: Remote output + 12V / 20mA (0.459mm² or 26x 0.15mm), 305mm length
• Red: + 12V ignition (ACC) fuse 2A (0.459mm² or 26x 0.15mm), 305mm length
• Black: mass (0.459mm² or 26x 0.15mm), 305mm length
• Cinch plug: red = right, white = left

OPTIONAL ACCESSORIES

• PRC-1 AMPIRE Bluetooth remote control
• 55100-CINCH AMPIRE noise filter

TECHNICAL SPECIFICATIONS:

• Voltage: + 12V DC
• Current consumption including remote output: <65mA
• Voltage / current remote output: + 12V DC, max.20mA
• Bluetooth 4.0
• CSR8635 chip
• Frequency range: 20Hz-20kHz
• Coding: Low Complexity Subband Codec (SBC)
• Bit rate: up to 345 kBit / s.
• Audio output voltage: 1V RMS
• Case dimensions: height: 20mm, width: 65mm, length: 50mm

BLUETOOTH APPROVAL:

• Declaration ID D025151
• Referenced Qualified Design ID 56386
• Listing Date 08 December 2014

TEACH DEVICE:

• make sure the bluetooth is turned on on your device
• turn on the ignition
• the LED (6) flashes blue (pairing mode)
• select BTR100 in the Bluetooth menu of your device to connect
• After a successful connection, the LED lights up continuously and a single beep sounds via the audio system

NOTE:

• Up to 9 devices can be connected to the BTR100, but only one device can stream music at a time.
• the BTR100 always remembers the device that was last learned and connects automatically when it is switched on
• a connection to another device must be carried out manually as described above
• if the connected device is out of range for more than a minute, the connection is automatically interrupted and the BTR100 goes into pairing mode [the LED (6) flashes]
• Can only be used in vehicles and not in continuous operation

SERVICE:

• all settings such as volume, music selection and play / pause are made on your device
• the BTR100 can be installed out of sight because it has no controls or buttons that need to be operated.