Ampire BTR400 - Bluetooth Receiver

If you want to be able to listen to your music, audio books or navigation wirelessly via Bluetooth in the car, then the Bluetooth receivers of the BTR series are the solution. You can retrofit wireless A2DP Bluetooth audio streaming to most navigation and car radio systems with the Ampire Bluetooth receiver.

The connection is easy to set up and is automatically restored via Bluetooth 4.0. The BTR series uses the Bluetooth protocol for headphones on your smartphone and does not affect the functionality of your Bluetooth hands-free system.

The BTR400 Bluetooth Receiver has been developed for navigation and car radio systems with cinch input (RCA) and power supply via USB.

With a 230V USB plug-in power supply available as an accessory, you can easily connect the BTR400 to the hi-fi system or television in your home in order to stream music wirelessly via Bluetooth in your own four walls.

FURNISHING

• splash-proof, marine certified
• automatic activation
• QDL licensed Bluetooth 4.0 CRS I9chip (CSR8635)
• A2DP in the highest EDR specification
• BT audio streaming also of lossless files such as wave, flac, lossless, etc.
• Cinch (RCA) with signal output 1.0V
• SSID display name: BTR400
• 10m range

SMARTPHONE COMPATIBILITY

• Android
• Apple iOS
• Microsoft

CONNECTIONS

• USB input (5 VDC power supply)
• Cinch (RCA) output

OPTIONAL ACCESSORIES

• PRC-1 AMPIRE Bluetooth remote control
• 55100-CINCH AMPIRE noise filter
• W44947 AMPIRE 230 volt power supply

TECHNICAL SPECIFICATIONS:

• Voltage: 5 volts DC
• Current consumption: <45mA
• Bluetooth 4.0
• CSR8635 chip
• Frequency range: 20Hz-20kHz
• Coding: Low Complexity Subband Codec (SBC)
• Bit rate: up to 345 kBit / s.
• Audio output voltage: 1V RMS
• Cable length: 300mm
• Case dimensions: height: 20mm, width: 65mm, length: 50mm

BLUETOOTH APPROVAL:

• Declaration ID D025151
• Referenced Qualified Design ID 56386
• Listing Date 08 December 2014

TEACH DEVICE:

• make sure the bluetooth is turned on on your device
• turn on the ignition
• the LED (6) flashes blue (pairing mode)
• select BTR400 in the Bluetooth menu of your device to connect
• After a successful connection, the LED lights up continuously and a single beep sounds via the audio system

NOTE:

• Up to 9 devices can be connected to the BTR400, but only one device can stream music at a time
• the BTR400 always remembers the last device that was taught in and connects automatically after being switched on
• a connection to another device must be carried out manually as described above
• if the connected device is out of range for more than a minute, the connection is automatically interrupted and the BTR400 goes into pairing mode [the LED (6) flashes]
• Can only be used in vehicles and not in continuous operation

SERVICE:

• all settings such as volume, music selection and play / pause are made on your device
• the BTR400 can be installed out of sight because it has no controls or buttons that need to be operated.