AMPIRE CAN-Bus Controller für Alarmanlagen

This CAN bus interface you can install a car alarm or remote start
systems in a modern car with CAN databus. The CAC100 interface can be
installed in many vehicles. Before the installation, the CAC100 need a
vehicle-specific firmware. To upload the firmware, you need the BL200
boot loader and a computer with USB port.


The following functions are possible depending on the type of vehicle:

IGNITION OUTPUT
FACTORY ALARM OUTPUT
FACTORY ALARM SIRENE INPUT
BONNET CONTACT OUTPUT
TRUNK CONTACT OUTPUT
TRUNK OPEN INPUT
DIRECTION LIGHT INPUT
DRIVER'S DOOR CONTACT OUTPUT
OTHER DOORS CONTACT OUTPUT
LOCK STATUS OUTPUT
PARKING BRAKE OUTPUT
BRAKE OUTPUT
ENGINE OFF OUTPUT
ENGINE ON OUTPUT
POWER WINDOWS OPEN INPUT
POWER WINDOWS CLOSE INPUT
POWER LOCK INPUT
POWER UNLOCK INPUT
POWER UNLOCK DRIVER DOOR INPUT


Important note:
Please
check with the car list in the download section which vehicles are
compatible. Not all features are on all vehicles and technically
possible, of course, depending on equipment. Please check after
installation if no malfunction and whether the data bus after falling
asleep at least 45 minutes. The current draw of the locked vehicle
before and after the installation of CAC100 should not increase
significantly.


Dimensions:
- 85x35x15mm