ACV 42sdc015 - LFB for Dacia Duster, 09/2021-2024 to 20Pin/32Pin

Steering wheel remote control adapter Dacia

Keep the original steering wheel remote control functions when replacing the factory radio with a retrofit radio.
Depending on the vehicle equipment and the range of functions and software of the retrofit device, individual operating functions may be omitted or replaced by other functions.
Compare the adapter plugs shown with those in your vehicle and make sure that they fit visually and technically.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check vehicle functions, vehicle settings and steering wheel remote control for functionality check.

Suitable for the following vehicles:

• Dacia Duster (SR) 09/2021 - 2024 

The following signals are provided:

• Reimported vehicles or vehicles with different software may be incompatible in terms of functions be.
• Steering wheel remote control

< h2>General installation instructions:
Check:

1: Check all operating functions and vehicle setting functions of the OEM device
2: Dismantle the OEM device without voltage
3: Check all interface connections for correctness and continuity without voltage make

Connection and connection sequence:

1: Make the settings and hardware configuration of the interface without voltage
2: Check the configuration of the radio connection cable
3: Connect the radio connection cable according to the operating instructions for the retrofit device
4: Connect all other connections according to the operating instructions for the retrofit device
5: Connect the entire installation to the vehicle with a live connection last
6: Configure the software of the interface according to the instructions in the article text and in the BDA
7: Configure the retrofit device according to the operating instructions for the retrofit device steering wheel remote control/camera/FSE/antenna phantom power and others
8: Test the function of the steering wheel remote control and Vehicle

Changes to the hardware configuration of the interface and the Radio connection cable:

1: Carry out changes without voltage applied
2: Connection after change see above 5 to 8

In case of malfunction of the interface or the Vehicle:

1: Revert to the OEM device
2: Operate the OEM device
3: Establish CAN bus rest
4: Check the hardware configuration of the interface
5: Connection after CAN bus rest see above 5 to 8
Connections, connection changes, alternative connections, connections of loose cables or Connection extensions of loose cables are intended solely for orientation and information purposes for trained specialist personnel.

Further connections, changes to the cable configuration of the wiring harness or use of alternative connections or Connection extensions:

1: Connections and modifications must only be carried out by trained specialist personnel
2: Connections and modifications must be checked before connection for any manufacturer approvals or manufacturer warranty conditions that may be affected by the changes
3: Connections and modifications must be checked before connection for function and correctness by measuring and comparing them with the vehicle's cable assignment plan
4: Connections and changes are made at your own risk and without guarantee of functionality
5: Connections and changes are made at your own risk and without guarantee of damage to the vehicle, the retrofit device or the interface
6: Changes to the pre-assembled wiring harness can void the product's warranty