ACV 13-1133-51 - Active system adapter Honda various vehicles

Active system adapter Honda

Metra 70-1730
This enables retrofit radios to be connected to a vehicle's own active system while retaining the OEM amplifier and the connected speakers by adapting, adapting or converting the output signals of the signal source to the signal input of the OEM amplifier.
Depending on the vehicle and the installed OEM active system, various functions such as faders or sound and subwoofer settings may be omitted.
In individual cases, depending on the OEM system and the retrofit radio, increased noise or a switching on or off noise may occur.
Check for functionality before final assembly.

Note:
Connection: 24 pin Honda connector
Connection: 8 pin Honda connector > OEM subwoofer
Vehicles with premium OEM sound system
Vehicles with OEM navigation > OEM subwoofer assignment may be different*
yellow: +12V continuous current terminal 30
red: +12V ignition current terminal 15
black: ground/GND terminal 31**
orange: +12V luminous flux terminal 51
orange/white: dimmer
blue: +12V antenna remote
blue/white: +12V amp remote
black/white: ground/GND terminal 31 OEM amplifier
brown: Mute
Low-level input:
RCA (f) gray: right front
Cinch(f) white: left front
Cinch(f) violet. right rear
Cinch(f) green: left rear
Cinch(f) white 8 pin: OEM subwoofer
Depending on the vehicle and equipment, the additional signals may vary
*16 pin connector: Pin 3 Sub+ / Pin 11 Sub- 
**Body mass direct > if not occupied

General installation instructions:

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are intended exclusively for orientation and information for trained specialist personnel.< br />Connections, changes to the wiring harness cable configuration or use of alternative connections or connection extensions:
1: Connections and changes must only be carried out by trained specialist personnel
2: Connections and changes must be checked before connection for any manufacturer approvals or for manufacturer warranty conditions that may be affected by the changes
3 : Connections and changes must be checked for function and correctness before connection by measuring and comparing using the vehicle's cable assignment plan
4: Connections and changes are made at your own responsibility with no guarantee of function
5: Connections and changes are made at your own risk with no guarantee of damage to the vehicle, the retrofit device or the interface
6: Changes to the pre-assembled wiring harness will void the product's warranty