ACV 42b-3474777 - LFB MAN TGA/TGL/TGM/TGS/TGX, 2007-2020

Steering wheel remote control adapter MAN

Keep the original steering wheel remote control functions when replacing the factory radio with a retrofit radio.
Depending on the vehicle equipment and the range of functions and software of the retrofit device, individual operating functions may be omitted or replaced by other functions.
Compare the adapter plugs shown with those in your vehicle and make sure that they fit visually and technically.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check vehicle functions, vehicle settings and steering wheel remote control for functionality.

Suitable for the following vehicles:

• MAN TGA 2007 -2020*
• MAN TGL 2007 - 2020*
• MAN TGM 2007 - 2020*
• MAN TGS 2007 - 2020*
• MAN TGX 2007 - 2020*

The following signals are provided:

Reimported vehicles or vehicles with different software may be incompatible in terms of functions.

• +12V ignition terminal 15
• +12V lighting terminal 58
• +12V reversing signal
• Speed signal
• Load capacity of total outputs: 200 mA max.
• Load capacity of individual outputs: 180 mA. max
• Current requirement greater than 180 mA:
• 1 relay coil resistance 75 Ohm min.
• 2 relays coil resistance 150 Ohm min.
• Steering wheel remote control

*Vehicles with ISO connection  > CAN bus in the ISO power plug
*Vehicles with 42 pin Quadlock plug:
Conversion adapter VAG 42Pin Quadlock>40Pin Quadlock > Article: 321328-24

General installation instructions:

Check:

1: Check all operating functions and vehicle setting functions of the OEM device
2: Dismantle the OEM device without power supply
3: Check all interface connections for correctness and continuity without power supply

Connection and connection sequence:

1: Make settings and hardware configuration of the interface without power supply
2: Check configuration of the radio connection cable
3: Connect the radio connection cable according to the operating instructions for the retrofit device
4: Connect all other connections according to the operating instructions for the retrofit device
5: Connect the entire installation to the vehicle with the live connection last
6: Software configuration of the interface according to the instructions in the article text and in the BDA
7: Configuration of the retrofit device according to the operating instructions for the retrofit device steering wheel remote control/camera/FSE/antenna phantom power and others
8: Function test of the steering wheel remote control and vehicle

Changes to the hardware configuration of the interface and the radio connection cable:

1: Make changes without power supply
2: Connection after change see above 5 to 8

If the interface or the Vehicle:

1: Revert to the OEM device
2: Operate the OEM device
3: Establish CAN bus rest
4: Check the hardware configuration of the interface
5: Connection after CAN bus rest, see above 5 to 8
Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are for guidance and information only for trained specialist personnel.

Other connections, changes to the cable configuration of the wiring harness or use of alternative connections or connection extensions:

1: Connections and changes may only be carried out by trained specialist personnel
2: Connections and changes must be checked before connection for any manufacturer approvals or manufacturer warranty conditions that may be affected by the changes
3: Connections and changes must be checked before connection by measuring and to check for functionality and correctness by comparing it with the vehicle's cable assignment plan
4: Connections and changes are made at your own risk and there is no guarantee of functionality
5: Connections and changes are made at your own risk and there is no guarantee of damage to the vehicle, the retrofit device or the interface
6: Changes to the pre-assembled wiring harness can void the product's warranty