ACV 42cxpdc-trafic3-1 - CAN Bus Interface Nissan Primastar/Renault/Trafic

CAN Bus Interface PDC

This CAN bus interface is used to restore the front and rear parking sensor tones after replacing the OEM device and provides additional signals for the retrofit device such as ignition current, reverse signal, lighting and speed signal in analog format.
The tones are reproduced via the optionally available LFB loudspeaker PDC 42a/42cx401/42cx402/42cxpdc-trafic3-1 > Article: 42cxpdc

Connection 20 pin Nissan connector:

• Pin 19 red  > red +12V continuous current terminal 30 fused
• Pin 20 black > black ground terminal 31

OEM cable colors may vary

CAN bus connection 32 pin Nissan connector:

• Pin 31 brown twisted > yellow CAN High
• Pin 32 green twisted > blau CAN Low
  

Connection 42cxpdc:

• Pin 5: 42cxpdc output red > article image 2
• Pin 11: 42cxpdc output black > Article image 2

Interface outputs:

• pink: +12V / 1.5A max. ignition current terminal 15
• white: +12V / 1.5A max. reverse gear when the engine is running
• orange: +12V / 0.1A max lighting terminal 58
• yellow/red: Speed signal

Status LED:

• blue flashing: CAN bus search
• blue permanent: CAN bus logged in
• blue/red permanent: output +12V ignition current terminal 15 active
• Dip switch without function

For the following vehicles:

Nissan

• Nissan Primastar (4/J4) 09/2021 - 2024

Renault

• Renault Trafic Combi (L/JL) 05/2021 - 2024
• Renault Trafic panel van (L/JL) 03/2022 - 2024
  

The following signals are provided:

Reimported vehicles or vehicles with different software may be incompatible in terms of functions.
Reversing alarm PDC front / rear

General installation instructions:

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are intended solely for orientation and information purposes for trained personnel. Specialist personnel.

Connections, changes to the cable configuration of the wiring harness or use of alternative connections or connection extensions:

1: Connections and changes may only be carried out by trained specialist personnel
2: Connections and changes must be checked before connection for any manufacturer approvals or for any manufacturer warranty conditions that may be affected by the changes
3: Connections and changes must be checked before connection for function and correctness by measuring and comparing them with the vehicle's cable assignment plan
4: Connections and changes are made at your own risk and without guarantee of function
5: Connections and changes are made at your own risk and without guarantee of damage to the vehicle, the retrofit device or the interface
6: Changes to the pre-assembled wiring harness will void the warranty of the Product