Axton ATS-FT160C - 2-way Compo system for Fiat Ducato

With the ATS-FT160C, the SPECIFIC series from AXTON has a precisely fitting plug & play 2-way component system for the Fiat Ducato III and identical models such as the Peugeot Boxer II, Citroen Jumper II and Opel Movano C. SPECIFIC means a precisely fitting design and vehicle-specific connectors as well as vehicle-optimized acoustics.

The woofer

The 16.5 cm woofer is equipped with the tried and tested CRYSTAX membrane from AXTON.
The naturally warm-sounding paper membrane is given greater rigidity by the additional coating with quartz crystals for a more impulsive bass reproduction and a faster response.
The woofer sounds very harmonious and still plays accurately; it clearly highlights instruments and voices, which is particularly valuable for lively music or audio books.

For technology enthusiasts

The intensive development work on the ATS-FT160C woofer is also convincing on paper.
The Klippel measurements demonstrate an extraordinarily high degree of symmetry in the force factor (Bl) and the spring stiffness of the oscillating unit (Kms).
Even with high deflections, the same forces act on the oscillating unit when the membrane enters and exits, which is a cornerstone for lifelike and low-distortion music reproduction.
For optimal use in the vehicle door, the woofer was tuned to a low Fs of 54 Hz and a Qts of 0.65.
On the one hand, this leads to high level stability and a powerful Bass and on the other hand gives the midrange a particularly harmonious and relaxed sound.

The tweeter

The tweeter has a 20 mm fabric dome and impresses with its brilliance and spatial reproduction.
The soft suspension in a filigree fabric surround enables the dome to reproduce the music details with great detail up to over 22 kHz.
Thanks to its vehicle-specific design, it fits exactly into the original holder, into which it is simply clipped.
For greater safety, the connection cables are covered with a foam tape; the plug fits perfectly into the original connection.

The crossovers

The crossovers are important for a correct acoustic connection between two components.
A good crossover ensures a stable and balanced sound. The woofer's crossover only requires a 6 dB filter and is supplemented by an LCR element to adapt the woofer to the characteristics of the Ducato vehicle acoustics.
The components are mounted on a stable circuit board with components on both sides, which is firmly screwed to the loudspeaker basket.
The tweeter is coupled with a high-quality MKP capacitor. It is also attached to a circuit board to ensure the tweeter assembly has a long service life.

DSP settings for absolute hi-fi enjoyment

 The ATS-FT160C is the first system in the AXTON SPECIFIC series to have a preset stored in the apps of the AXTON DSP amplifiers A544DSP and A594DSP for use in the Fiat Ducato.
This sound profile uses the time correction and the numerous equalizer bands to perfect the sound in the Fiat Ducato.
The presets are available free of charge in the A544DSP or A594DSP app.

Technical data ATS-FT160C

• Nominal load capacity 80 W RMS
• Frequency response 55 Hz - 22 kHz
• Impedance 3 Ohm
• Sensitivity 90 dB

Scope of delivery:

• 2 x woofers with integrated crossover
• 2 x tweeters with cable crossover
• 2 x AXTON Specific Label (metal brushed)

Product features ATS-FT160C

•  16.5 cm woofer: precisely fitting speaker design, vehicle-specific connections, ferrite magnet, on-board 6 dB/oct. crossover, NOMEX centering spider, 25 mm voice coil, AXTON CRYSTAX membrane, rubber surround
•  20 mm tweeter: fabric dome, fabric surround, ferrofluid-cooled voice coil, vehicle-specific connections
•  6 dB/oct. tweeter cable crossover, 6dB/oct. Woofer crossover with LCR circuit

Vehicle compatibility

• Citroen Jumper II 2006 to present
• Fiat Ducato III 2006 to present
• Peugeot Boxer II 2006 to present
• Ram Pro Master 2013 to present
• Opel/Vauxhall Movano 2021 to present

Installation only in the front doors.