ACV 42a-1353-000 - LFB for Volvo S60/V60/S70/V70/XC70

Steering wheel remote control adapter Volvo

Keep the original steering wheel remote control functions when replacing the factory radio with an aftermarket radio.
Depending on the vehicle equipment and the range of functions and software of the aftermarket device, individual operating functions may be omitted or replaced by other functions.
Compare the adapter plugs shown with those in your vehicle and make sure that they fit visually and technically.
Please also check whether one of the specified original factory radios was installed in your vehicle.
Before final assembly, check vehicle functions, vehicle settings and steering wheel remote control for functionality.

Suitable for the following vehicles:

• Volvo S60/V60 I (R) 09/2000 - 06/2004
• Volvo S60/V60 I (R) 06/2004 - 06/2009
• Volvo S70/V70/XC70 II (S) 05/2000 - 06/2004
• Volvo S70/V70/XC70 II (S) 07/2004. 01/2008

The following signals are provided:

Reimported vehicles or vehicles with different software may be incompatible in terms of functions.

• pink: +12V ignition terminal 15 1.5A max.
• orange: +12V lighting terminal 58 0.1A max.
• white: +12V reverse signal 1.5A max.
• yellow/green yellow/red: speed signal
• Steering wheel remote control

General Installation instructions:

Check:

1: Check all operating functions and vehicle setting functions of the OEM device
2: Dismantle the OEM device without voltage
3: Check all interface connections for correctness and continuity without voltage make

Connection and connection sequence:

1: Make the settings and hardware configuration of the interface without power
2: Check the configuration of the radio connection cable
3: Connect the radio connection cable according to the operating instructions for the retrofit device
4: Connect all other connections according to the operating instructions for the retrofit device
5: Connection of the entire installation to the vehicle with a live connection last
6: Software configuration of the interface according to the instructions in the article text and in the BDA
7: Configuration of the retrofit device according to the operating instructions of the retrofit device steering wheel remote control/camera/FSE/antenna phantom power and others
8: Function test of the steering wheel remote control and vehicle

Changes to the hardware configuration of the interface and the radio connection cable:

1: Make changes without power supply
2: Connection after change see above 5 to 8

If the interface or the vehicle malfunctions:

1: Revert to the OEM device
2: Operate the OEM device
3: Establish CAN bus silence
4: Checking the hardware configuration of the interface pan>
5: Anschluss nach CAN Bus-Ruhe see above 5 to 8
Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the operating instructions are intended solely for orientation and information purposes for trained personnel. Qualified personnel.

Additional connections, changes to the cable configuration of the wiring harness or use of alternative connections or Connection extensions:

1: Connections and modifications must only be carried out by trained specialist personnel
2: Connections and modifications must be checked for any manufacturer approvals or manufacturer warranty conditions that may be affected by the changes before connection
3: Connections and modifications must be checked before connection by measuring and by the The adjustment must be checked for functionality and correctness using the vehicle's cable assignment plan
4: Connections and changes are made at your own risk and there is no guarantee of functionality
5: Connections and changes are made at your own risk and there is no guarantee of damage to the vehicle, the retrofit device or the interface
6: Changes to the pre-assembled wiring harness can void the product's warranty